paint ledger board
1. carefully determine the height for the ledger—which will also be the height for all the joist framing. the top of the ledger board should be lower than the desired top of the finished deck by one decking board’s thickness, plus the thickness of the flashing (usually 1/8 inch).. Ledger board is a structural member that is mounted to a vertical frame. usually, its size is 2" by 10" or 2" by 12" piece of sturdy lumber. also called a ribbon board or strip, the ledger board is used to attach the deck to the frame of the house.it provides a strong and solid surface where floor joists, posts, and deckings can be attached.. Apr 24, 2019 - explore roger clark's board "ledger board-siding" on pinterest. see more ideas about building a deck, diy deck, decks and porches.. 
paint ledger board New costs were the wainscoting (48x96 panel was $20, and 2 ledger boards $5ea). the general process was pretty simple. removed my baseboard (i probably could have just rested it on top actually), cut the wainscoting and affix to the wall (i just used brad nails in the 3 studs, no need to glue it down in this location), frame out the finger. Step 6 - remove the ledger board. remove the ledger board from the house then and squeeze and apply silicone caulk into each pre-drilled hole. the silicone will act as a moisture seal for the areas where lag bolts are inserted. step 7 - attach the ledger board. place the ledger board back into the cutout area of the house and use lag screws to.
